Also available in store at the following retailers:
Not all models are available at all locations/retailers. If you have questions regarding availability of a particular model, please call your local store or Rainfresh support.
Whole House Water Filter Connector Kits
Installs water filter housings easily
No soldering or special fittings required
Model
Description
CK1P
Solderless connector kit for use with Rainfresh and other standard water filter housings with 3/4″ connections
Includes easy quick-connect fittings , 3/4″ full flow ball valve, and Teflon tape
For use on 3/4″ copper, PEX or CPVC pipe
CK2P
Solderless connector kit for use with Rainfresh and other valve-in-head water filter housings with 3/4″ connections
Includes easy quick-connect fittings and Teflon tape
For use on 3/4″ copper, PEX or CPVC pipe
CK3
Connector kit for use with Rainfresh and other undersink water filter housings with 1/2″ cold water connections and 3/8″ faucet connection
For use on copper or PEX pipe
Includes easy quick-connect fittings, compression valve, mounting bracket and Teflon tape
CK4
Rainfresh and other high flow water filter housings with 1″ connections
For use on copper or PEX pipe (Note : For use with PEX pipe, filter housing must be supported by mounting bracket BH010-6)
Includes easy quick-connect fittings and Teflon tape
Water Softener Connector Kits
Model
Description
CKS
Specifically designed for easy installation of water softeners & other conditioners
Connects conditioners with 3/4″ Male NPT connections to 3/4″ copper or PEX pipe
Features two (2) flexible stainless steel connectors that can be bent or oriented in any direction
Each connector has a 3/4″ quick connect fitting on one side and a ¾” female threaded fitting on the other
Install water conditioners in minutes. Saves time, effort and money !
CKS1
Same as CKS but with 1″ female threaded connection instead of 3/4″
Connects water conditioners with 1″ male threaded connections to 3/4″ copper or PEX pipe
Have more questions? Enter you own question below and our customer service will get back to you within 24 hours.
Water filter connector kit is an excellent way of installing water filters without the need for soldering or expensive PEX crimping tools. The water filter connector kit includes simple compression and threaded fittings. Installation can be completed just with the use of an adjustable wrench.
Water softener connector kit is even easier.
Rainfresh CKS1 is a solderless connector kit designed for installing water conditioners with 1” male threaded connections to ¾” PEX, copper or CPVC pipe.
NOTE
Envirogard assumes no responsibility for failure due to improper installation
For use with cold water only
Follow local plumbing codes
Do not expose to corrosive agents
Do not use pipe dope or thread sealants to make a connection
Do not make sharp bends or kink the connector in any way
INSTALLATION
Turn off water supply and open a faucet to de-pressurize the lines
Cut the cold water pipe at a convenient location where you have chosen to install the water conditioner
De-burr the ends with a knife, file or any other appropriate tool. Make sure that the cut is clean, straight and there is no debris on the end of the pipes. Warning: Do not use a saw to cut the pipe as it cause burrs and rough cuts that can cut the O-ring seal in the connector and cause leaks
Apply some silicone lubricant on the pipe to ensure that the connector slides smoothly over the pipe
After completing the filter installation, open the supply valve slowly to check for leaksTo remove the connector, turn water supply off & de-pressurize lines. Depress the white collet fully while pulling the connector out.
There are no reviews yet, would you like to submit yours?